Whirlpool Bathtubs

Depending on the model of the hot tub, the weight can go from 80kgs to 120kg approximately.

The whirlpool tub has a multicolour spotlight that changes colour automatically; these LEDs are red, green and blue and by combining them, 7 different colours are achieved.

When you purchase the extra skirt panels to your order, you receive 3 of them (1 front and 2 side skirts) for rectangular or king-size bathtubs and 1 curved skirt for corner bathtubs.

Yes, it is possible, but it is advisable to install the bathtub with skirt panels, as it is very easy to remove them in the event of a possible failure.

The whirlpool baths are sent completely assembled, all you have to do is unpack and place the bathtub, adjust its legs so that it's stable, make the connections for hot and cold water, drainge and electricity.

Once connected, fill the bathtub to check that all the connections have been made correctly and seal the edges in contact with the wall with silicone or a specific product.

Yes, you need a 220V electrical socket with a grounding point, hot and cold water and a drainage.

Here are the steps to follow to activate the self-cleaning function on whirlpool tubs that have this option:

-Empty the bathtub completely after using the bath.
-Choose the water flow selector to let the water flow out of the jets.
-Turn the flow selector to let the water flow out.
-Let the water run out for a few minutes so that the ducts can be cleaned and thus remove any remains of dirt
This procedure avoids the accumulation of residues and dirt in the internal pipes of the whirlpool tubs.

Black whirlpool baths add a modern touch to a bathroom. To maintain their shine, here are a few tips.

After each use, we recommend cleaning and drying the bathtub with a soft cloth so that no dirt or limescale remains and does not accumulate.

In the case of using a cleaning product, it should first be used on a small non-visible area of the bathtub to check the correct result.

It is the customer's responsibility to maintain and clean the bathtub to prevent dirt or limescale build-up.

To remove the fittings it is necessary to access from the faucet side ( taps )

1. Loosen the nut and remove the screw that holds the white plastic piece.

2. Loosen the screws that hold the metal piece to be able to turn it and remove the skirt.

To remove the skirts from your rectangular or king size bathtub, you must first remove the front skirt.

The front skirt is anchored to the structure by 3 hooks.

Pull the skirt out from the bottom, in correspondence of the 3 hooks.